| 1. | These configurations apply to both single ended and to push pull output stages
这些结构都适用于单端和推挽功率级。 |
| 2. | A simple class - a / ab has been proposed in where the current of the output stage is signal dependent
简单的一类a / ab被提出，在这一类中，输出阶段的电流是相互依赖的。 |
| 3. | In the output stage of the converter , a small filter is treated as an integral part of the dc - to - dc converter
在变流器的输出级，一个小的滤波器作为直流-直流变流器整体的一部分。 |
| 4. | When analysing output stage , i try using the miler theorem to analyse it , so quantitative analysis can be deduced and understood easily
在分析输出级时，尝试了用密勒定理分析，这样，定量的分析容易推导、理解。 |
| 5. | This type of configuration requires a much higher power supply voltage , since the power supplied to the output stage is supplied through this load resistor
这种结构需要一个很高地电源高压，因为输出级的高压需要通过负载电阻。 |
| 6. | The lower supply also makes the dynamic range of signal reduced . this requires the op - amp a rail - to - rail input and output stage
电源电压的降低也使得信号的动态范围极大减小，这就要求运算放大器能做到输入轨对轨和输出轨对轨。 |
| 7. | Third , rail - to - rail amplifier output stages exhibit load - dependent gain which affects amplifier open - loop gain , and hence closed - loop gain accuracy
第三，轨到轨放大器输出级增益与负载有关，这将影响放大器的开环增益,当然也影响了闭环增益的准确性。 |
| 8. | 3 . the output stage of transimpedance amplifier is realized with rail - to - rail topology to meet the requirement of output swing of the instrumentation amplifier
3 .针对仪表放大器的输出摆幅的要求,在跨阻放大器的输出级采用rail - to - rail结构来实现。 |
| 9. | A push - pull output stage was used in the circuit to extend output voltage from rail to rail and a class ab biasing is used to improve the power efficiency of the circuit
输出级采用共源结构的互补推挽输出结构，提高了输出电压的动态范围。并使用甲乙类的输出结构，提高了电路的功率效率。 |
| 10. | The drive stage is made up of cascode class - f topology . a “ big ” mosfet is used in the class - e output stage . the thesis did the simulation of the pa by ads with the tsmc 0 . 18 m rf cmos model , and completed the layout of the pa
本文设计了一种新颖的射频cmos功率放大器,采用两级差分结构,用f类共源共栅结构作为驱动级,输出级采用大尺寸mos管的e类功率放大器。 |
